
Fuller color, tighter joints and easier washing
Paver Sealing in Oldsmar, FL
Call (656) 254-5347 today for a free paver sealing estimate in Oldsmar, FL.
- Brings out deeper paver color
- Fresh joint sand helps lock pavers in place
- Gives weeds less room to grow
- Makes the surface easier to keep clean
- Free estimate, no obligation
Request a Free Estimate
Free, no obligation.
How fast can I get paver sealing in Oldsmar?
A local contractor can seal your Oldsmar pavers, and you will hear back within 1 business day, usually much sooner. The estimate is free, and you are free to say no. To start, call (656) 254-5347.
Sealing deepens faded color, holds joint sand in place and makes pavers easier to wash. The driveway looks cared for again, weeds find fewer gaps to root in, and Unilock says a sealed surface needs only soap, water and a broom for routine cleaning. Tell the contractor how each area gets used, since a driveway takes tires and oil while a pool deck takes water and bare feet. When you are ready, send the short estimate form.
Paver Sealing Oldsmar Is Proud to Serve Tampa Bay

What is included in a paver sealing job?
A sealing job covers a surface check, a wash, fresh joint sand and the sealer itself. The wash comes first, because sealer locks in whatever is left on the pavers. To hear how those steps apply to your pavers, call (656) 254-5347.
Surface check
The contractor notes sunken spots, stains, old sealer and places where water collects. Anything that needs repair is priced before sealer goes on.
Washing
Dirt, algae and film come off with a surface cleaner, since sealer would trap them. The pavers then dry before the next step.
Joint sand
Fresh sand goes back into the joints and is swept or misted as the product requires. Full joints stop pavers from shifting and crowd out weeds.
Sealer coats
The chosen sealer goes down on a dry surface at the coverage rate printed on its label. A second coat follows only if the product and the pooling on the first coat call for it.
How do I know my pavers need sealing?
Pavers need sealing when the color has faded, the joints have lost sand, weeds push through or water soaks in instead of beading. Lost sand lets weeds in and lets pavers start to shift, and that repair costs more than a maintenance coat. To have yours looked at, call (656) 254-5347.
Which type of sealer suits Florida pavers?
Two families of sealer are common, water-based and solvent-based. Unilock lists water-based products as lower in odor, lower in gloss and easier to clean up. It lists solvent-based products as the choice for high shine and heavy traffic. To ask which one fits your surface, call (656) 254-5347.
Unilock puts solvent-based sealer life at about four to five years and coverage at 80 to 120 square feet per gallon. Water-based products cover about 100 to 150 square feet per gallon. A contractor's gallon count for your job should land in that range, so ask for the count in writing when you send the short estimate form.
Oldsmar homes sit close to the bay. Unilock notes that in coastal, sunny parts of Florida, a sealer with strong resistance to UV light and salt can help. Western Interlock, a paver supplier, advises against one water-based acrylic sealer where sprinklers overspray or the coast is near. To ask why a contractor chose their product for a bay-side home, call (656) 254-5347.
Should I choose a wet look or a matte finish?
Choose wet look for deeper color and shine, and choose matte to stay near the natural look. Family Handyman describes film-forming sealers as wet and glossy and non-film-forming ones as matte. Unilock warns that high gloss can be slippery when wet and says a matte sealer keeps more traction. A sunny driveway and a splashed pool deck may call for different finishes. Ask for a test patch when you send the short estimate form.
How often should pavers be sealed in Oldsmar?
Plan on resealing every three to five years. Unilock and Belgard both give that range, and Western Interlock says three to four. Open sun, sprinklers and daily car traffic push toward the short end. Family Handyman adds that a shaded yard may need a wash every year while a sunny one can go a few years. If splashed water soaks in and stops beading, the coat is thinning, so call (656) 254-5347.
Does more sealer mean more protection?
No. Extra sealer buys no extra protection. Belgard says sealer should not go on more than once in three years, with at most two applications, because too many coats leave a film that can discolor in sunlight. Unilock ties a whitish film to over-application or trapped moisture. Western Interlock warns about hot surfaces and stacked coats. Treat an offer built on extra coats with care, and ask what coverage the label calls for before you send the short estimate form.
When is the right time to seal pavers?
The right time is a dry stretch, and for new pavers it comes only after the white haze has cleared. Belgard says to wait at least 30 days after installation, and Unilock says efflorescence usually needs 2 to 3 months and sometimes up to a year. To pick a date that fits your install, call (656) 254-5347.
Florida's wet season matters too. Nearly two thirds of the year's rain in Pinellas County falls from June through September, so a dry week in summer is worth taking. Unilock asks for clear skies 24 to 48 hours ahead and a range of 50 to 90 degrees Fahrenheit, with 75 the sweet spot. Western Interlock warns that sealer may fail once the paver surface passes 90 degrees, and pavers in full sun run hotter than the air. That is why early starts make sense here. To book a morning slot, send the short estimate form.
Will sealing fix sunken pavers or standing water?
No, sealing will not fix pavers that have sunk or water that sits in one spot. Unilock cautions that sealer cannot cure poor drainage or a weak base. Oldsmar rests on a plateau that never climbs above 20 feet, and UF/IFAS notes that fill is often brought in to raise a lot for drainage, so low spots are worth asking about. Find out whether leveling is part of the price when you send the short estimate form.
Which paver surfaces can be sealed?
Sealer can go on a driveway, a pool deck, a patio or a walkway. Each wears in its own way, so the plan follows how you use the space. To start with yours, send the short estimate form.
Driveways
Cars, oil drips and all-day sun wear a driveway faster than any other paved spot. Sealing here deals with the fading and the stains that tires and sun leave behind.
Pool decks and lanais
Splash water, sunscreen and bare feet all land on a pool deck. Sealing here has to leave the surface draining well and not slick, so the method and the product both matter.
Patios
A shaded patio stays damp, and damp is where green growth starts. Sealing on a patio is mostly about getting that growth off and slowing its return.
Walkways and entries
Walkways run beside beds, mulch and sprinklers, so soil and water reach them first. Sealing at the front entry fixes what guests see before they knock.
What paver problems are common in Oldsmar?
Five paver problems come up around Oldsmar: sun fading, green growth, lost joint sand, sprinkler stains and failed old sealer. To have yours looked at, call (656) 254-5347.
1. Color fading in open sun
Strong sun bleaches unprotected pavers, and a driveway with no shade fades first. A fresh coat brings depth back, and Unilock lists UV resistance as a reason to seal in sunny parts of Florida.
2. Green growth in damp corners
Oldsmar sits on Old Tampa Bay, and the air stays humid. Shaded walkways and north sides stay damp, which is what algae needs, and that film turns slick on a pool deck or front walk.
3. Joint sand lost to summer rain
Nearly two thirds of the year's rain in Pinellas County falls from June through September, often as afternoon storms. Hard rain carries sand out of the joints, and open joints let weeds in.
4. Rust colored sprinkler marks
UF/IFAS says most Florida well water is high in iron, and iron leaves rust deposits on whatever it touches. Orange streaks along edges and low walls point to irrigation, and they get treated before any sealer locks them in.
5. Cloudy or flaking old sealer
Unilock ties a whitish film to trapped moisture, too much sealer or an earlier product that does not mix with the new one. The old coat is dealt with first.
What does paver sealing cost in Oldsmar?
Paver sealing in Oldsmar commonly runs $1.50 to $2.50 per square foot, which is the range one Tampa Bay company publishes for the town. That price covers rotary washing, re-sanding and two coats of acrylic sealer. Family Handyman's national range is $1 to $2. To turn those ranges into a figure for your home, send the short estimate form.
Square footage sets most of the price, and condition adjusts it. Weeds, oil stains and sunken pavers add prep time, and the sealer finish changes the material cost. Stripping a failed old coat and leveling are usually extra. If a wash is all your pavers need, the cleaning guide has the details. The service area list and the Oldsmar home page show the rest. To price your own job, call (656) 254-5347.
| Paved area | Typical example | Clean, sand and seal |
|---|---|---|
| 300 sq ft | Small patio or walkway | $450 to $750 |
| 600 sq ft | Two car driveway | $900 to $1,500 |
| 1,000 sq ft | Large driveway or pool deck | $1,500 to $2,500 |
| 1,500 sq ft | Driveway plus pool deck | $2,250 to $3,750 |
Math based on the $1.50 to $2.50 per square foot that Tampa Bay paver companies publish. Your contractor sets the actual price after seeing the surface. Repairs, leveling and stripping failed sealer are usually extra.

Why use a local contractor for paver sealing?
A local contractor already works under the same sun, summer storms and bay humidity your pavers face. Take the written price home and decide in your own time. To get started, call (656) 254-5347.
A contractor who works in your area
Your request goes to a local contractor who covers Oldsmar and the towns around it. You hear from someone who knows how Pinellas County weather treats pavers.
Free, and easy to decline
The estimate is free, and you can say no once you see the price. Nothing is signed until you decide.
A price you can check
Published Tampa Bay paver rates are quoted by the square foot, and this site shows that range. You can hold any quote up against it.
You keep control
You choose whether to hire the contractor, which finish goes on and when the work happens. Read what to look for in a contractor, then get the price in writing.
How do I get a free paver sealing estimate?
Call, or send the short form. A contractor from your part of Pinellas County gets back to you inside 1 business day, often much sooner.
Free, no obligation

How do pavers look after sealing in Oldsmar?








How does the paver sealing process work?
The paver sealing process runs in five steps, from a walk of the surface to a final look with you. The order matters, since each step sets up the next. To get on the schedule, call (656) 254-5347.
1. Walk the surface
The contractor checks for sunken spots, stains, old sealer and low spots where water sits. A puddle that lingers after rain gets noted now, since sealer will not fix it.
2. Wash with a surface cleaner
A rotary surface cleaner on a pressure washer lifts dirt and algae in even passes. Unilock suggests keeping the spray angle under 30 degrees so the joint sand stays put.
3. Refill the joints
Once the pavers dry, fresh joint sand is swept in. Polymeric sand, which hardens when it is misted with water, is a common pick for holding joints in place.
4. Apply the sealer
On a dry surface, an acrylic sealer goes down with a pump sprayer or a foam roller, the tools Unilock lists. A dry roller then lifts any pooled sealer so streaks and lap marks do not form.
5. Walk it with you
The contractor shows you the finished surface and gives the wait times. One Tampa Bay company says feet after 24 hours and cars after 48.
Frequently Asked Questions
How often should pavers be resealed in Florida?
Plan on every three to five years, the range Unilock and Belgard both give. Western Interlock says three to four. Open sun, sprinklers and daily cars push toward the short end.
How long does wet look sealer last on pavers?
Unilock puts high shine, solvent-based sealer at four to five years when it is kept up, and the wider three to five year range covers most products. Sun, sprinkler overspray and car traffic shorten it, and a covered lanai can stretch it.
Can you seal outdoor pavers?
Yes, driveways, pool decks, patios and walkways can all be sealed. Unilock says concrete and brick pavers are porous and brick soaks up more, so the sealer should match the material. Ask the contractor what the product was made for.
Is it better to spray or roll paver sealer?
Either works, and many jobs use both. Unilock lists a pump sprayer or a foam roller, with a dry roller to lift pooled sealer. Western Interlock says to spray it on and not pour out a bucket and chase the puddles.
What is the average cost to seal pavers in Florida?
One Tampa Bay paver company publishes $1.50 to $2.50 per square foot for Oldsmar to wash, re-sand and seal. On a 600 square foot driveway in Oldsmar that works out to roughly $900 to $1,500. Repairs and stripping are extra.
Is there a downside to sealing pavers?
Yes. Sealing repeats every three to five years, and Unilock says better sealers cost more. High gloss finishes can turn slippery when wet, and an old coat has to be tested for a match before a new one goes over it.
How long does a paver sealing job take in Oldsmar?
Plan on one to two days. One Tampa Bay company describes a two day job for a two car driveway, with washing and prep on day one and sealing on day two so the surface can dry. A summer storm can move the schedule.
How long should you stay off pavers after sealing?
Plan on about 24 hours before walking on them and about 48 before parking, which is what one Tampa Bay company lists. Unilock asks for up to 48 hours of dry weather so the sealer cures and says to keep sprinklers off.
Can you seal pavers around a pool in Oldsmar?
Yes. Unilock says pool decks that see splash and sunscreen gain from the moisture and mildew resistance of a sealer. Ask for a finish that keeps traction, because a high gloss coat can get slick when wet.
Does salt air from Old Tampa Bay change which sealer to use in Oldsmar?
It can. Unilock says a product with strong UV and salt resistance helps in coastal, sunny parts of Florida. Western Interlock advises against one water-based acrylic sealer near the coast or where sprinklers overspray. Ask why the contractor chose theirs.
Ready to seal? Ask for your free paver sealing estimate
Dial the number or use the short form, and a nearby contractor answers inside 1 business day, often much quicker. Turning down the quote costs nothing.
Free, no obligation
